Dell 320-8277, U2410 manual Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Back to Contents Page

Setting Up the Monitor

Dell™ U2410 Flat Panel Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing Your Cables

Attaching the Soundbar (optional)

Attaching the Stand

NOTE: The stand is detached when the monitor is shipped from the factory.

To attach the monitor stand:

1.Remove the cover and place the monitor on it.

2.Fit the two tabs on the upper part of the stand to the groove on the back of the monitor.

3.Press the stand till it snaps into its place.

Connecting Your Monitor

WARNING: Before you begin any of the procedures in this section, follow the safety instructions.

NOTE: USB uplink cable connection enables USB ports and card reader on the monitor to work.

To connect your monitor to the computer perform the following steps/instructions:

•Turn off your computer and disconnect the power cable.

•Connect the USB uplink cable.

•Connect either the white (digital DVI-D) display connector cable, the blue (analog VGA) display connector cable, or the black DisplayPort cable to the corresponding video port on the back of your computer. Do not use all the cables on the same computer. Use all the cables only when they are connected to different computers with appropriate video systems.

Connecting the White DVI Cable and USB uplink cable