Back to Contents Page
Replacing the Front I/O Panel
Dell Studio XPS™ 435MT Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1.Follow the procedures in Before You Begin.
2.Remove the computer cover (see Replacing the Computer Cover).
3.Remove the front panel (see Replacing the Front Panel).
4.Remove any expansion cards, if necessary (see Replacing a PCI Express Card).
CAUTION: Carefully note the routing of each cable before you disconnect it, so that you are sure to
5.Disconnect the cables connected to the I/O panel from the system board.
6.Remove the screw that secures the I/O panel to the chassis.
7.Carefully remove the existing I/O panel from the computer.
1 | I/O panel clamp slot | 2 | cables |
3 | I/O panel clamp | 4 | screw |
5I/O panel
8.To replace the I/O panel, align and slide the I/O panel clamp into the I/O panel clamp slot.
9.Replace the screw that secures the I/O panel to the chassis.
10.Connect the cables to the system board.
11.Replace any expansion cards, if necessary (see Replacing a PCI Express Card).
12.Replace the front panel (see Replacing the Front Panel).
13.Replace the computer cover (see Replacing the Computer Cover).
14.Connect your computer and devices to electrical outlets, and turn them on.
