7DEOH0HVVDJH6\VWHP&DXVH0HVVDJHVFRQWLQXHG&RUUHFWLYH$FWLRQ
Diskette | Faulty or improperly | Replace the diskette. |
drive 0 seek | inserted diskette, | Run the System Setup |
failure | incorrect configura- | program to correct the |
| tion settings in | diskette drive type. |
Diskette | System Setup | Check the diskette drive |
drive 1 seek | program, loose | interface cable and |
failure | diskette drive inter- | power cable connec- |
| face cable, or loose | tions to the drive. |
| power cable |
|
|
|
|
Diskette | Faulty diskette, | Check the diskette drive |
read failure | faulty or improperly | interface cable and |
| connected diskette | power cable connec- |
| drive interface | tions to the drive. |
| cable, or loose | Replace the diskette |
| power cable | drive interface cable. |
|
|
|
Diskette | Faulty diskette drive | Replace the system |
subsystem | controller (defective | board. |
reset failed | system board) |
|
|
|
|
Diskette | Diskette write- | Move the |
write | protect feature | tab on the diskette. |
protected | activated |
|
|
|
|
Drive not | Diskette missing | Reinsert or replace the |
ready | from or improperly | diskette. |
| inserted in diskette |
|
| drive |
|
|
|
|
ECC host bus | Defective system | Replace the system |
parity | board | board. |
interrupt at |
|
|
address |
|
|
ECC memory | Faulty or improperly |
parity | seated DIMM, |
interrupt at | DIMMs not installed |
address | in sets of four, a |
| faulty or improperly |
| seated memory |
| module, or a defec- |
| tive system board |
Be sure that the DIMMs are installed in sets of four and in the proper sockets for each mem- ory bank in use. If this does not resolve the problem, remove and reseat the DIMMs and then the memory mod- ule. If the problem persists, replace the DIMMs or the memory module. If the problem still persists, replace the system board.