Removing and Replacing Parts 4-27
*XLGH%UDFNHW$VVHPEO\To remove the guide bracket assembly, follow these steps:
1. Remove the system board.
2. Remove terminator card and SEC cartridge/heat sink assemblies if
necessary.
3. From the underside of the system board, use a T25 Torx driver to remove
the screws at each end of the bracket(s) (see Figure 4-22).
4. For each guide bracket, squeeze the bracket retaining tabs on the under-
side of the system board to release the bracket, and pull the bracket away
from the system board.
NOTE: Because of the way the guide brackets overlap each other, the guide
bracket assembly must be removed in the following order: PROC_4 (the
bracket shown being removed in Figure 4-22), PROC_3, PROC_2, PROC_1.
Reinstall them in reverse order.
screws (2)
guide bracket