NOTE: Your DRAC contains an integrated
NOTE: If your DRAC is configured to the same IP address as another NIC on the same network, an IP address conflict occurs. The DRAC stops responding to network commands until the IP address is changed on the DRAC. The DRAC must be reset even if the IP address conflict is resolved by changing the IP address of the other NIC.
NOTE: Changing the IP address of the DRAC causes the DRAC to reset. If SNMP polls the DRAC before it initializes, a temperature warning is logged because the correct temperature is not transmitted until the DRAC is initialized.
•NIC Selection
NOTE: NIC Selection cannot be configured on modular systems
NOTE: The NIC Selection option is available only on 11G and earlier systems.
•Primary and Failover Network options
For 12G systems, the Primary Network options for Remote Management (iDRAC7) NIC are: LOM1,
LOM2, LOM3, LOM4, and Dedicated. The Failover Network options are: LOM1, LOM2, LOM3, LOM4, All LOMs, and None.
NOTE: The Dedicated option is available when the iDRAC7 Enterprise License is present and valid.The number of LOMs varies based on the system or hardware configuration.
•Enable IPMI Over LAN
•IP Address Source
•IP Address
•Subnet Mask
•Gateway Address
•Channel Privilege Level Limit
•New Encryption Key
5.Configure the following optional VLAN configuration details:
NOTE: VLAN configuration is not applicable for systems with iDRAC.
•Enable VLAN ID
•VLAN ID
•Priority
6.Configure the following IPv4 Properties:
•IP Address Source
•IP Address
•Subnet Mask
•Gateway Address
7.Configure the following IPv6 Properties:
•IP Address Source
•IP Address
•Prefix Length
•Default Gateway
•DNS Address Source
64
