Dell C6220 II Interposer Extender for 2U Node

Removing and Installing System Components | 179

CAUTION: Using excess thermal grease can cause grease to contact the

processor shield, which can cause contamination of the processor socket.

8 Place the heat sink on the processor. See Figure 3-19.

9 Using a Phillips screwdriver, tighten the heat-sink retention screws. See

Figure 3-19.

10 Replace the system-board assembly. See "Installing a System-Board

Assembly" on page 171.

11 Reconnect the system to its electrical outlet and turn on the system,

including any attached peripherals.

12 Press <F2> to enter the System Setup program, and check that the

processor information matches the new system configuration. See

"System Setup Options at Boot

<F2>

Initiate Setup during POST

<F8>

Load customized defaults

<F9>

Load optimal defaults in Setup menu.

<F10>

Save Settings and exit in BIOS Setup

13 " on page 68.

Interposer Extender for 2U Node

1 Remove the system-board assembly. See “Removing a System-Board

CAUTION: Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your

product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came with

the product.

NOTE: This section is applicable to systems with 2U node only.