210 | Removing and Installing System Components
When securing the cable tie, make the cable tie go through the second air
hole (from the bottom to the top) and then tighten it to encircle one of the
mini-SAS cables. And meanwhile ensure the other mini-SAS cable is held
by the cable-tie clip.
Figure 3-39. Cable Tie for 2U Node
LSI 9265-8i RAID Battery

Removing the LSI 9265-8i RAID battery Assembly

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
NOTE: The information in this section applies only to systems intalled with the LSI
9265-8i card.
1 Remove the system-board assembly. See “Removing a System-Board
Assembly" on page 170.
2 When removing the LSI 9265-8i RAID battery assembly for 1U node,