Dell C6220 II owner manual Disable Enable Power Button Pass, Jumper Function Pin1-2 Pin2-3

System Configuration Jumper Settings on the C6220 System Board

The function of system configuration jumper installed on each C6220 system board is shown below:

Figure 5-19. System Configuration Jumpers on the C6220 System Board

Table 5-2. System Configuration Jumper on the C6220 System Board

Jumper	Function	Off	On
	Service Mode	*Disable	Enable
	NVRAM Clear	*Disable	Enable
	BIOS Recovery	*Disable	Enable
	ME Firmware Recovery	*Disable	Enable
	MEDBG1	*Disable	Enable
	Power Button Pass	*Disable	Enable

Jumper	Function	Pin1-2	Pin2-3
	PWRD_EN	*Enable	Disable

NOTE: The * in the table of system configuration jumper describes the default status and the default state is not active state.

Jumpers and Connectors 341