134 Removing and Installing Parts
6
Replace the support bracket (see "Replacing the Support Bracket" on
page173), and then press down the card retention bracket to seat it on its slot.
7
Ensure that:
• The guide clamp is aligned with the guide notch.
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
8
Replace the computer cover, reconnect the computer and devices to
electrical outlets, and then turn them on.
9
Remove the card’s driver from the operating system.
10
If you removed a sound card:
a
Enter system setup (see "System Setup" on page 185), go to
Onboard
Devices
and select
Integrated Audio
and then change the setting to
On
.
b
Connect external audio devices to the audio connectors on the back
panel of the computer. See "Back Panel Connectors" on page23.
11
If you removed an add-in network connector:
a
Enter system setup (see "System Setup" on page 185), go to
Onboard
Devices,
and select
Integrated NIC
, and then change the setting to
On
.
NOTICE: To connect a network cable, first plug the cable into the network
device and then plug it into the computer.
b
Connect the network cable to the integrated connector on the back
panel of the computer. See "Inspiron 530sa/530sc" on page19 and
"Inspiron 530sb/530sd" on page21.
book.book Page 134 Monday, October 6, 2008 11:38 AM