Dell DCSLF - page 152

152 Removing and Installing Parts
11 Replace the CD/DVD drive (see "Installing a CD/DVD Drive" on
page155).
12 Replace the bezel (see "Replacing the Bezel" on page136).
13 Replace the computer cover (see "Replacing the Computer Cover" on
page174).
14 Connect your computer and devices to electrical outlets, and then turn
them on.
Installing a Media Card Reader
1 Follow the procedures in "Before You Begin" on page 103.
2 Remove the computer cover (see "Removing the Computer Cover" on
page105).
3 Remove the bezel (see "Removing the Bezel" on page 135).
4 If this is a new card reader installation:
• Remove the drive panel insert (see "Removing the FlexBay Drive Panel
Insert" on page 149).
• Remove the Media Card Reader from its packaging.
5 Remove the CD/DVD drive (see "Removing a CD/DVD Drive" on
page154).
6 Remove the FlexBay drive insert (see "Removing the FlexBay Drive Panel
Insert" on page 149).
7 Press the two spring clamps and slide out the FlexBay drive cage from the
front of the system (see "Removing a Floppy Drive" on page144).
8 Place the Media Card Reader in the FlexBay drive cage and slide the
Media Card Reader in to align the screw holes in the Media Card Reader
with the cage notch.
9 Tighten the two screws to secure the floppy drive in the FlexBay drive cage.
10 Slide the FlexBay drive cage along with the floppy drive in the FlexBay slot
till it snaps in place.
11 Connect the FlexBay USB cable to the back of the Media Card Reader and
to the internal USB connector on the system board (see "Inside View of
Your Computer" on page108).
book.book Page 152 Monday, October 6, 2008 11:38 AM