140 Removing and Installing Parts
NOTE: The location of connectors on the system board may vary depending on
your compute. See "Inside View of Your Computer" on page108.
6
Press in on the securing tab on the side of the drive and slide the drive up
and out.
7
If removing this drive changes the drive configuration, then be sure to
reflect these changes in system setup. When you restart your computer,
enter system setup (see "System Setup" on page185), then go to the
"Drives" section of the System Setup and under
Drive 0 through 3
, set the
Drive to the correct configuration.
8
Replace the support bracket (see "Replacing the Support Bracket" on
page173).
9
Replace the computer cover (see "Replacing the Computer Cover" on
page174).
10
Connect computer and other devices to an electrical outlet.
1shoulder screws (4) 2system board
connector
3power cable
4serial ATA data cable 5hard drive
4
2
3
1
5
book.book Page 140 Monday, October 6, 2008 11:38 AM