Preparing Your Systems for Clustering 37
To connect to the storage system:
1
On the cluster node, open the Navisphere Server Utility.
2
Select
Configure iSCSI Connections on this cluster node
and click
Next
.
3
Select
Configure iSCSI Connections
and click
Next
.
4
In the
iSCSI Targets and Connections
window, select
Discover iSCSI
targets using this iSNS server
to send a request to the iSNS server for all
connected iSCSI storage-system targets, and click
Next
.
5
For each target you want to log into:
a
In the
iSCSI Targets
window, select the IP address of the Inactive
target.
b
In the
Login Options
section, select
Also login to peer iSCSI target
for High Availability
(recommended) if the peer iSCSI target is listed.
c
If you selected the
Also login to peer iSCSI target for High
Availability
option (recommended) in stepb, leave the Server
Network Adapter IP set to Default. This allows the iSCSI initiator to
automatically fail over to an available NIC in the event of a failure.
d
Click
Logon
to connect to the selected target.
e
If the CHAP authentication is enabled on the target, a CHAP login
dialog box is displayed.
Enter the CHAP security information. If you also use mutual CHAP
for the software Initiator to authenticate the target, select the
Mutual CHAP
option and click
OK
.
6
Click
Next
. If the
Network Interfaces (NICs)
window is displayed, go to
step 7. If the
Server Registration
window is displayed, go to step8.
7
In the
Network Interfaces (NICs)
window:
a
Deselect any NICs that are used for general network traffic and click
Apply
. A confirmation dialog is displayed stating that the network
settings for your NICs have been updated and you must restart your
system to apply them.
b
Click
OK
and then click
Next
.
8
In the
Server Registration
window, click
Next
to send the updated
information to the storage system.
9
Click
Finish
to close the wizard.