Installing and Configuring a Failover Cluster | Dell EMC AX4-5I

Installing and Configuring a Failover Cluster

You can configure the operating system services on your Failover Cluster, after you have established the private and public networks and have assigned the shared disks from the storage array to the cluster nodes. The procedures for configuring the failover cluster are different depending on the Windows Server operating system you use.

For more information on deploying your cluster with Windows Server 2003 operating systems, see the Dell™ Failover Clusters with Microsoft Windows Server 2003 Installation and Troubleshooting Guide located on the Dell Support website at support.dell.com. For more information on deploying your cluster with Windows Server 2008 operating systems, see the Dell Failover Clusters with Microsoft Windows Server 2008 Installation and Troubleshooting Guide located on the Dell Support website at support.dell.com.

Preparing Your Systems for Clustering

41

Image 41

Dell EMC AX4-5I manual Installing and Configuring a Failover Cluster

Contents

Hardware Installation and Troubleshooting Guide April Contents Installing the Microsoft iSCSI Cluster Configuration Overview Introduction Introduction Cluster Hardware Requirements Cluster Solution Identical Cluster NodesCluster Node Requirements Component Minimum Requirement Requirement Cluster StorageCluster Storage Requirements Ethernet Switches Dedicated to iSCSI Supported Cluster ConfigurationsNICs Dedicated to iSCSI Direct-Attached Cluster Private network ISCSI connections Storage system ISCSI SAN-Attached Cluster Private network Ethernet switch Storage systemOther Documents You May Need Page Cabling Your Cluster Hardware Cabling the Power SuppliesCabling the Mouse, Keyboard, and Monitor Cabling Your Cluster Hardware One AC PDU not shown Cabling Your Cluster for Public and Private Networks Private network Cluster node Cabling the Public NetworkNetwork Connections Description Private Network Hardware Components and Connections Method Cabling the Private NetworkNIC Teaming Cabling Storage for Your Direct-Attached Cluster Cabling the Storage Systems Cabling Your Cluster Hardware Gigabit Ethernet Cabling Storage for Your iSCSI SAN-Attached ClusterPorts AX4-5i storage array Storage system Cabling Your Cluster Hardware Public network Private network Gigabit Ethernet switch Storage system Cabling Your Cluster Hardware AX4-5i storage system Page Storage systems Obtaining More Information Preparing Your Systems for Clustering Cluster Configuration Overview Preparing Your Systems for Clustering Installation Overview Installing the Microsoft iSCSI Software Initiator Installing the iSCSI NICs Start the Registry Editor. a Select Start→ Run Modifying the TCP Registry SettingsInstalling EMC PowerPath Configuring the Shared Storage System System Software window, click Upgrade Software Preparing Your Systems for Clustering Configuring the iSCSI Initiator using iSNS Preparing Your Systems for Clustering Network Interfaces NICs window On the cluster node Open the Navisphere Server Utility Configuring the iSCSI Initiator without iSNS Apply Page Installing and Configuring a Failover Cluster Preparing Your Systems for Clustering Troubleshooting Troubleshooting Support.microsoft.com Support.microsoft.com Minimum value Check all cable connections Services window Click ServicesCluster Services Window, click the Recovery Support.microsoft.com Public IP Address Private IP Address Cluster Data Form Cluster Data Form Number of Attached DAEs Virtual Disks ISCSI Configuration Worksheet ISCSI Configuration Worksheet Index Storage systems, 25 connecting to one shared storageIndex Mscs