Installing Drives 7-9
)LJXUH$WWDFKLQJ'LVNHWWH'U LYHRU7DSH'ULYH&DEOHV
 )RU DQ(,'(WDS HGULYHRU& '520GULYH FRQQHFWW KHRWKHUHQG RIWKH
LQWHUIDFHFDEOHWRWKHLQWHUIDFHFRQQHFWRUODEHOHG´,'(µRQWKHV\VWHP
ERDUG
For a diskette drive or non-EIDE tape drive, connect the cable from the drive to
the interface connector labeled “DSKT” on the system board.
For a drive that comes with its own controller card, connect the other end of the
interface cable to the controller card.
Check all cable connections. Fold cables out of the way to provide airflow for the
fan and cooling vents.
 ,IWKH LQFKGULYHED\ ZDVSUHYLRXVO\H PSW\UHPRYHWKHIURQW SDQHO
LQVHUWIURPWKHIURQWEH]HO
See “Removing and Replacing Front-Panel Inserts” found earlier in this chapter.
 5HSODFHWKHIURQWEH]HO
 5HSODFHWKHFRPSXWHUFRYHUUHFRQQHFW\RXUFRPSXWHUDQGSHULSKHUDOV
WRDQHOHFWULFDORXWOHWDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
diskette/tape d rive
interface cable
DC power cable
interface connector
power input connector