Dell GX1 P manual LJXUH5HPRYLQJDULYH, $Wwdfkwkheudfnhwwrwkhqhzgulyh

NOTE: For easier access inside the chassis, you may want to rotate the power supply out of the way temporarily. To do so, see “Rotating the Power Supply Away From the System Board” in Chapter 5.

bracket tabs (2)

)LJXUH￿￿￿￿￿￿￿5HPRYLQJ￿D￿'ULYH￿

If a drive is already installed in the bay and you are replacing it, be sure to dis- connect the DC power cable and interface cable from the back of the drive before sliding the bracket out of the bay. To remove the old drive from the bracket, turn the drive/bracket assembly upside down and unscrew the four screws that secure the drive to the bracket (see Figure 7-7).

￿￿$WWDFK￿WKH￿EUDFNHW￿WR￿WKH￿QHZ￿GULYH￿

Turn the drive upside down, and locate the four screw holes around its perimeter. Fit the bracket over the drive, and then tilt the front of the drive up so that the bracket drops down into place. To ensure proper installation, all screw holes should be aligned and the tabs on the front of the bracket should be flush with the front of the drive (see Figure 7-7).

5.25-inch drive

bracket tabs (2)

bracket

)LJXUH￿￿￿￿￿￿￿$WWDFKLQJ￿WKH￿'ULYH￿%UDFNHW￿WR￿WKH￿1HZ￿'ULYH￿

Installing Drives 7-7