Dell GX1 P )LJXUH6\VWHP%DWWHU\DQG%DWW HU\6RFNHW

6-16 Dell OptiPle x G X1 and GX1p Mini Tower Ma naged PC Systems Re fer ence and Insta ll ation Guide
The battery (see Figure 6-1) is mounted in a socket labeled “BATTERY,” in the
front-right corner of the system board (as you face the front of the system).
Pry the battery out of its socket with your fingers or with a blunt, nonconductive
object, such as a plastic screwdriver.
 ,QVWDOOWKHQHZEDWWHU\
Orient the battery with the side labeled “+” facing up (see Figure 6-11). Then
insert the battery into the socket, and snap it into place.
)LJXUH6\VWHP%DWWHU\DQG%DWW HU\6RFNHW
 5HSODFHWKHH[SDQVLRQFDUGFDJHDVGHVFULEHGLQ´5HSODFLQJWKH
([SDQVLRQ&DUG&DJHµLQ&KDSWHU
 5HSODFHWKHFRPSXWHUFRYHUUHFRQQHFW\RXUFRPSXWHUDQGSHULSKHUDOV
WRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
 (QWHUWKH6\VWHP6HWXSSURJUDPFRQILUPWKDWWKHEDWWHU\LVRSHUDWLQJ
SURSHUO\DQGUHVHW&KDVVLV,QWUXVLRQWR1RW'HWHFWHG
See Chapter 2, “Using the System Setup Program,” for information on running
the System Setup program and resetting the Chassis Intrusion category.
Enter the correct time and date through the System Setup program’s Time and
Date categories. Also, use the copy you made in step 1 to restore the correct set-
tings for other system configuration information. Then exit the System Setup
program.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
 7XUQRII\RXU��FRPSXWHUDQGXQSOXJLWIRUDWOHDVWPLQXWHV
BATTERY
socket
battery