Dell GX1 P manual Qvwdoolqjdq,+Duglvnulyh, Surjudp, 9HULI\WKDW\RXUV\VWHPZRUNVFRUUHFWO

￿￿￿7R￿UHVHW￿WKH￿FKDVVLV￿LQWUXVLRQ￿GHWHFWRU￿￿HQWHU￿WKH￿6\VWHP￿6HWXS￿SURJUDP￿ DQG￿UHVHW￿&KDVVLV￿,QWUXVLRQ￿WR￿1RW￿'HWHFWHG￿

See Chapter 2, “Using the System Setup Program,” for instructions.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.

￿￿￿8SGDWH￿\RXU￿V\VWHP￿FRQILJXUDWLRQ￿LQIRUPDWLRQ￿LQ￿WKH￿6\VWHP￿6HWXS￿

SURJUDP￿

For a diskette drive, update the appropriate Diskette Drive option (A or B) on Page 1 of the System Setup screens to reflect the size and capacity of your new dis- kette drive. (For more information, see Chapter 2, “Using the System Setup Program.”)

If you installed a non-EIDE tape drive as the second drive, set the Diskette Drive B category to Not Installed.

For EIDE CD-ROM and tape drives, set the appropriate Drive option (0 or 1) under Drives: Secondary to Auto.

￿￿￿9HULI\￿WKDW￿\RXU￿V\VWHP￿ZRUNV￿FRUUHFWO\￿

See your Diagnostics and Troubleshooting Guide for information on running the Dell Diagnostics and troubleshooting any problems that may occur. Use the fol- lowing guidelines to determine which test to use:

‡If you installed a diskette drive, test it by running all of the subtests in the Diskette Drive(s) test group of the Dell Diagnostics.

‡If you installed a CD-ROM drive, see the documentation that came with the drive for instructions on loading device drivers and using the drive. If it is an EIDE CD-ROM drive, test it by running all of the subtests in the IDE CD-ROM Drives test group of the Dell Diagnostics.

‡If you installed a tape drive, first verify that your diskette drive is still operat- ing correctly by running all of the subtests in the Diskette Drive(s) test group of the Dell Diagnostics. Then perform a tape backup and verification test with the drive as instructed in the tape-drive software documentation that came with the tape drive.

NOTE: Tape drives sold by Dell come with their own operating software and doc- umentation. After you install a tape drive, refer to the documentation that came with the drive for instructions on installing and using the tape drive software.

,QVWDOOLQJ￿DQ￿(,'(￿+DUG￿'LVN￿'ULYH

This section includes information on installing, partitioning, and formatting EIDE hard- disk drives. For instructions on installing, partitioning, and formatting SCSI hard-disk drives, see “Installing SCSI Devices” found later in this chapter.

Up to two EIDE drives (one of which must be 1 inch high or less) can be installed in the hard-disk drive bracket below the drive cage. The first EIDE drive is installed in the

7-10 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide