DellTM XFR D630 Fully Rugged Notebook Service Manual

Touch pad connector

1

touch pad connector

 

 

14.2Installing the Palm Rest

NOTICE: When reinstalling the palm rest, ensure that you reconnect the USB cable to the IO dash board, and then reconnect the touch pad cable connector to the system board before replacing the palm rest screws.

NOTE: If you are replacing the palm rest, remove the USB Control cable from the original palm rest and route the same way in the new palm rest.

Underside of Palm Rest showing Touchpad Cable Route

Touchpad cable

1.Install the 5 top-side screws.

2.Turn the system over.

3.Install the 11 bottom screws.

4.Reconnect the coin-cell battery (see Coin-Cell Battery).

Page 80 of 106

Revision A01

Page 80
Image 80
Dell XFR D630 service manual Installing the Palm Rest, Underside of Palm Rest showing Touchpad Cable Route