Dell XFR D630 service manual Removing the Processor

DellTM XFR D630 Fully Rugged Notebook Service Manual

processor thermal-cooling assembly. The new processor thermal-cooling assembly has new pads already installed.

5.Install the heat sink. Place the processor thermal-cooling assembly on the system board.

6.Tighten in consecutive order the four captive screws, labeled "1" through "4," on the thermal- cooling assembly.

7.Replace the fan cover and secure with the 4 screws.

8.Replace the palm rest (see Installing the Palm Rest).

NOTE: Ensure that you reconnect the coin-cell battery (see Coin-Cell Battery) before you replace the keyboard.

9.Replace the display assembly (see Installing the Display Assembly).

10.Replace the keyboard (see Keyboards).

11.Replace the media bay device (see XBay Devices).

12.Replace the hinge cover (see Installing the Hinge Cover).

13.Replace the battery.

18 Processor

18.1Removing the Processor

CAUTION: Before working inside your computer, follow the safety instructions in the XFR D630 Product Information Guide and in the XFR D630 User’s Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

NOTICE: To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press, to apply slight pressure to the center of the processor while turning the cam screw.

NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.

1.Follow the instructions in Before You Begin.

2.Remove the hinge cover (see Removing the Hinge Cover).

3.Remove any installed media bay device (see XBay Devices).

4.Remove the keyboard (see Keyboards).

5.Remove the display assembly (see Removing the Display Assembly).

6.Remove the palm rest (see Removing the Palm Rest).

Page 88 of 106 Revision A01