Delta 33-830 instruction manual Assembling Table Board Clamps and Table Boards

ASSEMBLING

TABLE BOARD CLAMPS AND TABLE BOARDS

1.Locate table board clamps (A) Fig. 29, and insert one clamp into each of the slotted holes (B) located at the rear of each table support bracket (C) as shown in Fig. 30.

2.Adjust clamps (A) Fig. 30, so that the clamps are open entirely as shown, by turning knobs (D).

3.Place 1-1/4″ wide board (E) Fig. 31, against front table board (G), 1-3/4″ wide board (H) in the upright position against 1-1/4″ board, and 5-3/4″ wide board (J) against 1-3/4″ wide board as shown. Then tighten knobs (D), until the table boards are securely clamped in position.

A

B

C

Fig. 29

A

D

D

A

Fig. 30

G

H

ADJUSTING AND CHECKING SAW BLADE TRAVEL SQUARE TO FENCE

D

DJ

Fig. 31

E

1.DISCONNECT TOOL FROM POWER SOURCE.

2.Position rear and middle table boards with 1-3/4″ wide fence board (H) Fig. 32, in the rear position as shown.

3.Raise track arm (A) Fig. 32, by turning elevating handle (B) until the blade (C) can be assembled on the motor shaft. Then tighten arbor nut (D) using the wrenches supplied.

4.Place a framing square (E) Fig. 32, against fence (H) and blade (C) as shown, and lower track arm (A) until the blade just clears the table surface.

B

A

C

H

D

E

Fig. 32

14