Tools Needed for Assembly and Adjustment | Delta 33-830 guide

ASSEMBLY

TOOLS NEEDED FOR ASSEMBLY AND ADJUSTMENT

Your Delta Radial Arm Saw can be assembled and adjusted using a few common hand tools, including:

• Phillips head screwdriver	• 7/16″ Wrench	• 1/2″ Socket, ratchet, and extension	• 3/16″ Allen Wrench
• Flat blade screwdriver	• 1/2″ Wrench	• Adj. Combination Square	• 1/4″ Allen Wrench
• Framing Square

ASSEMBLING LEGS TO SAW BASE

1.Loosen lock knob (A) Fig. 8, and move cutting-head

(B) to the rear position as shown. Then tighten knob (A).

2.IMPORTANT: Make certain the cutting-head is clamped securely at the back of the track arm.

3.Place Radial Arm Saw on its back and assemble legs

(C) Fig. 9 (three of which are shown assembled) to each corner of saw base (D) using sixteen 5/16-18 x 5/8″ carriage head screws (E), flat washers (G), external tooth lockwashers (H), and hex nuts (J). Place flat washer on bolt. Insert bolt through holes then assemble lockwasher and nut. Hand tighten, hardware at this time but do not completely tighten. Also refer to hardware Fig. 4.

4.Stand the saw in the upright position and securely tighten all stand hardware.

A

B

Fig. 8

C

D

CH

J

ASSEMBLING WRENCH HOOK TO SAW BASE

1.Assemble wrench hook (K) Fig. 10, to the front right (as shown), or back left, side of saw base (D), using two #10 x 1/2″ shet metal screws.

E

G

Fig. 9

D

K

Fig. 10

9

Image 9

Delta 33-830 instruction manual Tools Needed for Assembly and Adjustment, Assembling Legs to SAW Base

Contents

10″ Professional Radial Arm Saw General Safety Rules Extension Cords Additional Safety Rules for Radial ARM Saws Power Connections Motor SpecificationsGrounding Instructions Overload Protection Changing Voltage Functional Description Unpacking and CleaningPage Explanation of Operating Controls Assembly Tools Needed for Assembly and AdjustmentAssembling Legs to SAW Base Removing Blade and Blade Guard from SAW Disconnect Tool from Power Source Assembling Track ARM Clamp Lever Assembling Adjusting Table Supports Contacts the table board before the motor is fully Track ARM Clamp Handle Y are Assembling Table Board Clamps and Table Boards Adjusting and Checking SAW Blade Travel Square to FencePage Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To Table Adjusting IN/OUT RIP Scale Tongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to Machine Cutting Into Table Boards Fastening SAW to the Floor ON/OFF Switch Adjusting Ball Bearings Against TrackMotor Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating Column Changing Position of Yoke Clamp Handle Changing Position of Bevel Clamp Handle Adjusting Splitter and ANTI-KICKBACK Fingers Positive Stop Yoke IndexPositive Stop Bevel Index Auxiliary Table Board Facing Using a Table ExtensionOperations CROSS-CUT Stop Ripping Compound Miter CuttingOUT-RIPPING IN-RIPPING Constructing a Push Stick Pushstick Two Year Limited Warranty PARTS, Service or Warranty AssistancePage Canadian PORTER-CABLE Delta Service Centers