TABLE LOCKING WRENCH STORAGE
The table locking wrench can be stored underneath the table as shown in Fig. 21.
BELT TENSION LEVER HANDLE
To attach the belt tension lever handle (II) Fig. 22, place it in hole (JJ) with the hole (AA) up, as shown.
Align set screw (BB) with hole (AA) Fig. 22 and tighten screw down into hole firmly with included hex wrench as shown in Fig. 23.
Place M6 x 1 locknut (LL) Fig. 23 on set screw (BB). Firmly tighten locknut (LL) with a 10 mm wrench.
Fig. 21
BB |
AA |
JJ |
II |
BB |
LL |
Fig. 23
YY |
Fig. 22
TABLE INSERT
The drill press table comes with an insert (XX) Fig. 23B made of MDF to help prevent wear and tear on the bit when it drills down through the workpiece.
Over time, it will become necessary to replace this piece. It can be made from 3/4" thick MDF cut into a
To replace the old insert :
1.Remove two screws from holes (YY) Fig. 23A that hold insert in place.
2.Remove old insert and place your new insert into the table (Fig. 23B).
3.If the insert is not level with the table, adjust the four jack screws (JJ) Fig. 23C. When the table insert is level, tighten the locking nut on each screw.
4.Hold down on the insert and secure it in place with the 2 screws that were removed in Step 1. Insert screws in holes (YY) Fig. 23A and secure insert in place.
Fig. 23A
XX |
Fig. 23B
JJ |
Fig. 23C
12
