Set up speakers | around items indicate the settings. |
Here we describe how to set up speakers other than |
|
For the method of setting up |
|
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
•Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage 68 “Set up “Amp Assign””).
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 69 “Set up “Channel Select””).
version Basic
1 | Set up the | 2 | Connect the setup microphone. |
| |||
remote control unit |
| ||
|
|
|
3 | Set up “Amp Assign” |
Use ui to select “Amp Assign”, and then press
Advanced
nn Set up the zone mode
Press ZONE SELECT to switch the zone mode to J(MAIN ZONE).
The J indicator lights.
Press ZONE SELECT
nn Set up the operation mode
Press AMP to set the remote control unit to AMP- operation mode.
When the setup microphone is connected, the following screen is displayed.
AUDYSSEY AUTO SETUP
STEP1 Preparation |
| 1 2 3 4 5 6 |
Connect the speakers and place them according | ||
to the recommendations in the manual. |
| |
Set the following items |
|
|
If necessary. |
|
|
Amp Assign |
|
|
Channel Select |
|
|
Auto Setup Start |
|
|
Enter | RETURN | Cancel |
Start Auto Setup |
|
|
ENTER.
AUDYSSEY AUTO SETUP
STEP1 Preparation | 1 2 3 4 5 6 |
Connect the speakers and place them according to the recommendations in the manual,
Set the following items If necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter RETURN Cancel
Change assigned power amp to match the speaker system
AMP ASSIGN | [1/2] |
|
|
Assign Mode ZONE2
ZONE2: 
ZONE3: 
RETURN Return
Assign power amp to ZONE2 stereo signal
version
Information
Press AMP
vSee overleaf
68