Cleaning discs
•If there are fingerprints or dirt on discs, wipe them off before using the disc. If not the sound quality could be reduced and the sound may be broken.
•Use a commercially available disc cleaning set or a soft cloth to clean discs.
Inserting the batteries
qRemove the remote control w Set two R6P/AA batteries in
unit’s rear cover. | the battery compartment in |
| the indicated direction. |
ENGLISH
|
| Getting | |
Operating range of the remote control unit |
| ||
|
| ||
• Point the remote control unit at the remote sensor when operating | Started | ||
it. | |||
| |||
• When used connected to other components in the F102 series, |
| ||
point the remote control unit at the remote control sensor of the |
| ||
receiver |
| ||
• The remote control unit can be used from a distance of up to about |
| ||
7 meters, at a horizontal angle of up to 30° with respect to the |
| ||
sensor. |
|
Gently wipe the disc from the | Do not wipe with a circular motion. |
inside towards the outside. |
|
NOTE:
•Do not use record spray, antistatic agents, or benzene, thinner or other solvents.
About the remote control unit
The included remote control unit
( page 32).
NOTE:
•The system remote control unit included with the receiver (DRA- F102/F102DAB) cannot be used to operate the
ePut the rear cover back on.
Notes on batteries:•Replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the unit. (The attached batteries are only for verifying operation.)
•When inserting the batteries, be sure to do so in the proper direction, following the “<” and “>” marks in the battery compartment.
•To prevent damage or leakage of battery fluid:
•Do not use a new battery together with an old one.
•Do not use two different types of batteries.
•Do not
•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.
•Remove the batteries from the remote if it will not be in use for long periods.
30° 30°
Approx. 7 m
NOTE:
•The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.
5
ENGLISH