Note: A qualified installer should make all electri- cal connections.

INSTALLATION

Continued

4.If you have not installed hood, follow instruc- tions on page 6. WARNING: If pre-wiring, do not connect wiring to any electri- cal source at this time.

Install fireplace electrical outlet and connect wiring to outlet before connecting to electrical source. The fireplace electri- cal outlet is included with the GA3450TA blower accessory.

Only use the fireplace electri- cal outlet supplied with the GA3450TA blower accessory.

Note: A qualified installer should make all electri- cal connections.

3.Install gas piping to fireplace location. This installation includes an approved flexible gas line (if allowed by local codes) after the equip- ment shutoff valve. The flexible gas line must be the last item installed on the gas piping.

4.If you have not installed hood, follow instruc- tions on page 6.

5.Carefully set fireplace in front of rough opening with back of fireplace inside wall opening.

6.Attach flexible gas line to fireplace gas regula- tor. See Connecting Equipment Shutoff Valve to Heater Control, page 17.

7.Bend four nailing flanges on outer casing with pliers (see Figure 9).

8.Attach fireplace to wall studs using nails or wood screws through holes in nailing flange.

Wall Studs

Nails or Wood Screws

9.Check all gas connections for leaks. See Check- ing Gas Connections, page 17.

10.If using optional brass trim kit, install the trim after final finishing and/or painting of wall. See instructions included with brass trim ac- cessory for attaching brass trim.

IMPORTANT: When finishing your firebox, combustible materials such as wall board, gypsum board, sheet rock, drywall, plywood, etc. may be butted up next to the sides and top edge of the fire- box. Combustible materials should never overlap the firebox front facing.

7.Bend four nailing flanges on outer casing with pliers (see Figure 9). WARNING: Do not allow any combustiblematerialstooverlap the firebox front facing.

IMPORTANT: Noncombustible materials such as brick, tile, etc. may overlap the front facing, but should never cover any necessary openings like louvered slots.

Figure 9 - Attaching Fireplace to Wall WARNING: Do not allow noncombustible materials to cover any necessary openings like louvered slots.

Manual background WARNING: Never modify or cover the louvered slots on the front of the firebox.

Manual background WARNING: Use only noncom- bustiblemortaroradhesiveswhen overlapping the front facing with noncombustible facing material.

Nailing

Manual backgroundManual background Flanges

Figure 9 - Attaching Fireplace to Wall

Studs

116658-01A

www.desatech.com

11

Page 11
Image 11
Desa CDCFPRA Note A qualified installer should make all electri- cal connections, Attaching Fireplace to Wall Studs