Desa CDCFNRA, CDCFPRA Continued, ON/OFF SERIES MODEL HRC101, THERMOSTAT SERIES MODEL HRC201

OPERATING FIREPLACE

Continued

Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

FlameControl

Adjustment Knob Knob

OUT IN

REMOTE
OFF
ON	LO

Selector Switch in Remote Position (Optional Remote Control)

Figure 40 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

ON/OFF SERIES (MODEL HRC101)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 41).

TO LOCK press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

TO UNLOCK press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

THERMOSTAT SERIES (MODEL HRC201)

The hand-held remote can be operated using either the manual mode (MANU) or thermo- static mode (AUTO) (see Figure 42). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Manual Mode

1.Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2.Press the MANU button to turn on the fireplace.

3.Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1.Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2.Press AUTO button to select this mode.

3.Set the desired room temperature by press- ing the TEMP + or - buttons.

4.Press the POWER and LOCK buttons together to turn off the fireplace

Note: Do not leave the hand-held remote in the AUTO mode close to the fireplace. The radiant heat from the fireplace will turn off the fireplace. Ideally, place the hand-held remote in the center

of the room facing towards the fireplace.
	Digital Display Shows
	Temperature and Settings
Locks		AUTO
	ROOM		SET
System to	TEMP		TEMP
Prevent	LOCK		POWER
Accidental		TEMP
Ignition

Indicator	Control
	Button
Light

Figure 41 - ON/OFF Hand-Held Remote Control Unit

Turns Burners On or Off

Increases or Decreases Room Temperature in AUTO Mode

MANU ºC/ºF AUTO

		Turns
		Hand-Held
		Remote On
		or Off and
°C/°F		Allows You
	Selects	to Choose
Mode		the Manual
	AUTO
Button		Setting
	Mode

Figure 42 - Thermostat Hand-Held Remote Control Unit

24 www.desatech.com 116658-01A