Desa (V) CB36(N Installing Optional Controls, Installing Optional Wall Mount Switch GWMS2

INSTALLING OPTIONAL CONTROLS

Installing Optional Wall Mount Switch - GWMS2 10

Installing Optional Wireless Hand-Held Remote Control - HRC100 Series

INSTALLING OPTIONAL CONTROLS

INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2

1.Connect one terminal of 15 ft. wire from the wall switch to the male connector on the high limit harness. Connect remaining wire terminal to the TH terminal on the valve. Make sure that the wire terminals are in the positions on the unit as pictured in Figure 16. If wires are not connected as shown the switch will not work.

2.Route the 15 ft. wire through hole openings with bushings provided on either side of the fireplace cabinet.

3.Connect one bare wire end to each of the terminals of the GWMS2 wall switch.

4.Install the wall switch and cover in the wall.

IMPORTANT: Do not use any other wire than that provided with theGWMS2wallswitchkit.Donotexceed15ft.ofdistancefromthe valve connection. Using wire of higher gage or turns or exceeding the minimum distance will increase resistance at the control valve causing unreliable performance of the fireplace controls.

Installing 9-Volt Alkaline Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into the battery housing. (see Figure 19).

3.Replace battery cover onto remote control unit..

Receiver

9-Volt Alkaline

Battery

Terminal Wires

Battery Clip

Figure 17 - Attaching Alkaline Battery to Receiver

Remote Receiver	Wire Harness	PLASTIC
or Wall Switch	From High	MOUNTING
		CLIPS
to Terminal	Limit Switch
Marked "TH"

REMOTE ON OFF

TOWARDS FRONT

REMOTE

RECEIVER

Male Connector to

Remote Receiver or Wall Switch

Figure 18 - Mounting Remote Receiver to Bracket

Figure 16 - Connecting Remote Receiver or Wall Switch to the Gas Control Valve

INSTALLING OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL - MODEL HRC100

Installing Remote Receiver

1.Open bottom louver and locate the switch bracket on the right

2.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt alkaline battery (not included) through the clip

3.Attach the terminal wires to the battery. (see Figure 17).

4.Connect one wire from receiver to the male connector on high limit harness and one to “TH” on control valve (see Figure 16).

5.Locate the two plastic mounting clips provided with the kit.

6.Use the clips to mount the receiver on remote mounting bracket. as shown in Figure 18.

Battery Cover	Remote
	Control Unit

Terminal

Wires

Battery

9-Volt Housing

Battery

Figure 19 - Installing Battery in Hand-Held Control Unit (HRC100 Series)

117437-01 www.desatech.com