HEARTH ACCESS AND ASSEMBLY
Removing Lower Louver Access Panel | 14 |
Removing Top Louver Trim Panel
Removing/Replacing Glass Door
HEARTH ACCESS AND ASSEMBLY
WARNING: If fireplace has been running, turn off and let cool before accessing or servicing the unit.
Removing Lower Louver Access Panel
1.Use your index fingers to locate the left and right spring latches found just under the top louver then draw them inward to release the pins holding the panel on the side face (see Figure 28).
2.Swing the louver panel out until it clears the fireplace opening.
3.Pull the entire panel out until the bottom tabs are free of the slot openings in the lower face frame.
2. Swing | Lower Louver |
Out Panel | Access Panel |
WARNING: Handle glass door panel with care. Do not strike, slam, or otherwise abuse glass. Do not operate fireplace with glass door removed, cracked, or broken.
Spring Clips
3. Pull
Out Panel
Panel Tab
Spring Latch
1.Lift Up Panel at Lower Rail
Glass Panel
Frame Rail
1. Draw Latches Inward | Locating Slot |
|
Figure 28 - Removing Lower Louver Access Panel | Figure 29 - Removing/Replacing Glass Door | |
Removing Top Louver Trim Panel
The top louver panel may be removed for inspection and cleaning by following the instructions for removing the lower louver access panel. (see Figure 28).
Removing/Replacing Glass Door
If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.
1.Placing a screw driver or your finger tips into the gap between the lower glass panel rail and the bottom face frame, lift the glass door assembly until the door pins clear the locating holes in the bottom face frame (see detail Figure 29).
2.Swing bottom glass panel assembly out until the door pins on the lower rail clears the bottom face frame (see Figure 30).
3.Lower the door down until the upper door pins are free of the locating holes in the spring clips and place in a safe area.
2.Swing Out Panel
3. Lower
Panel Out
Glass Panel
Frame Rail
Locating Hole
Door Pin
4. Replace glass panel in reverse order by inserting the top door |
| |
pins into the spring clips, lifting up at the lower frame rail, | Figure 30 - Removing/Replacing Glass Door | |
andlocatingthebottompinsintheholesonthelowerfaceframe. |
| |
|
| |
|
|
|
www.desatech.com | ||
