15 | HEARTH ACCESS AND ASSEMBLY (Cont.) |
Installing Logs and Glowing Embers | |
|
|
|
|
|
|
HEARTH ACCESS AND ASSEMBLY
Continued
INSTALLING LOGS AND GLOWING EMBERS
A 4 piece ceramic log set comes packed inside the unit firebox. Removal of glass door is necessary to unpack and assemble the logs and add hearth treatments. Follow steps under Removing/Replacing Glass Door, page 14 to access the logs and burner.
Assemble the logs and add burner treatments as follows:
1.Position the base log onto burner log mounts. (see Figure 31).
Note: The cut out on the bottom should fit over the mounts and the base log should be positioned against the rear panel
2.Position the holes on the bottom of the rear log over the pins on the base log Figure 31).
3.Position the top left log and top right log onto the rear log and base log as shown in (see Figure 31).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
4.Open the bag of ember materials.
5.Break apart about quarter sized pieces and place about a single layer along the full length of the ember tray to hide the bottom edge of the base log. (see Figure 32).
6.Replace the glass door and louver panels. See Removing/ Replacing Glass Door, page 14.
| TOP |
| |
TOP | RIGHT |
| |
LOG |
| ||
LEFT | EMBER | ||
| |||
LOG |
| TRAY | |
REAR |
| EMBER | |
LOG |
| MATERIAL |
Figure 32 - Applying Ember Material
REAR LOG | REAR | |
PANEL | ||
STAND | ||
|
LOG
MOUNTS 
BURNER
PAN
Figure 31 - Installing Logs
www.desatech.com |
