DeWalt DeVILBISS manual To Assemble Wheels, Assemble Rubber Strip if equipped, To Add Oil To Pump

6.If the handle has excessive movement, it is improperly installed. Check the following.

A.Are both tabs inside the handle (Step #3)?

B.Does each clip pass through both the saddle and handle (Step #4)?

To Assemble Wheels

It will be necessary to brace or support one side of the unit when installing

the wheels because the compressor will have a tendency to tip.

1.Attach wheels with shoulder bolts and nuts as shown.

Wheel

Nut

Shoulder Bolt

Nut

Flat

Washer

Rubber Foot

Screw

Assemble Rubber Strip (if equipped)

1.Remove the protective paper strip from the adhesive-backed rubber foot strip. Attach the rubber foot strip to the bottom of the air tank leg. Press firmly into place.

Tank Leg

Rubber

Foot Strip

2.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.

The wheels and handle do not

provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.

Assemble Rubber Feet (if equipped)

1.Attach rubber feet with the screws, washers and nuts provided as shown.

2.Tighten securely.

To Add Oil To Pump

Compressors are shipped without

oil. A small amount of oil may be present in the pump upon receipt of the air compressor. This is due to plant testing and does not mean the pump contains oil. Do not attempt to operate this air compressor without first adding oil to the crankcase. Serious damage can result from even limited operation unless filled with oil and broken in correctly. Make sure to closely follow initial start-up procedures.

D23766 10- ENG