11.The forward pivots of the step arms (K2 & K3) will arrive with the fixing hardware pre‐installed as depicted. Remove the hardware assembly (parts J1, J2 and J3) from the step arms and set aside.
12.Spacer K1 should remain in place on the pivot axles.
13.Bring the pivots of the left step arm (K3) and handlebar (H1) together. Slide the handlebar pivot over the step arm pivot axle and press into place.
14.Thread fixing nut J3 onto the pivot axle and tighten with the provided wrench.
15.Insert hex screw J1 through pivot cap J2 and install on step arm K3.
16.Repeat steps 12 through 16 for the right side assembly.
12
