Digi TS 4, TS 2/4 manual Set user name=name n1=telephone-number

set user name=name outgoing=on device=device

where device is either the Digi-supplied device or the outbound device created earlier in this pro- cedure

Example:

set user name=pppout outgoing=on device=gendialer

8.To configure an IP address for the local end of the PPP connection, enter the following com- mand:

set user name=name localipaddr=ip-address

where name is the user’s name and ip-addressis one of the following:

•0.0.0.0. , which means that the user will request an IP address from the remote server.

•A specific IP address, which means that the Digi device will attempt to use this IP address. The remote server must agree to this request.

Example: set user name=pppout localipadr=0.0.0.0

9.To configure a telephone number to dial to reach the outbound user, enter the following com- mand:

set user name=name n1=telephone-number

where name is the user’s name and telephone-numberis the number to dial to reach the user. You can enter this number as digits only, with dashes (-) separating digits, or with commas.

Example: set user name=pppout n1=4452624

Example

This example shows a very simple outbound PPP configuration. Here are some points on this configuration:

•The port is set up for outbound connections (dev=mout).

•Hardware flow control is used.

•Default device and scripts are used

set ports range=3 device=mout

set flow range=3 ixon=off ixoff=off rts=on cts=on set line range=3 baud=115000

set user name=pppout protocol=ppp

set user name=pppout dialout=on outgoing=on device=gendialer

set user name=pppout localipadr=0.0.0.0

set user name=pppout n1=4452624

8-6 Configuring Outbound PPP Connections: Command Line