21
1998
O
w
n
er
’
s
Ma
n
ual
TEMPERATURE PADS
Pushing the UP pad increases the temperature and pushing the DOWN
pad decreases the temperature. Push the respective pad one time for each
degree of temperature change. The existing spa water temperature will
remain in the digital display window until a temperature pad is pushed.
When the UP or DOWN pad is pushed the digital readout will indicate
the new temperature setting, with a solid ▲symbol in the upper left cor-
ner of the display. Once the new temperature is set, the current spa water
temperature will again be indicated. The spa will heat to the pre-set tem-
perature automatically.
LIGHT
Push the LIGHT pad to turn the spa light on. Push this pad again to turn
the spa light off. If the light is left on, it will automatically turn off after
4 hours.
PROGRAMMING THE PROGRAMMABLE DIGITALCONTROL
To initiate the programming sequence at any time, push the UPpad and
the PUMP pad in sequence within 3 seconds. To move to the next pro-
gramming feature, push the PUMP pad again.
CLOCK SET
Push the UP pad and the PUMP pad in sequence within 3 seconds to
engage the time setting mode. The time screen will appear with “hours”
(_ _.00) flashing on and off. Push the UP or DOWN pad to increase or
decrease the number until the desired hour appears. AM and PM will
change each time the number goes past 12. When the desired number is
displayed, push the PUMP pad to accept the selection and change the
flashing number to the “ten minute” place (12:_0). Adjust the number
with the UP or DOWN pad in the same manner as the hour number.
When the desired number is displayed, push the PUMP pad to accept the
selection and change the flashing number to the “minute” place (12:1_).
Adjust this number with the UP or DOWN pad in the same manner as the
hour number. When the desired number is displayed, push the PUMP
pad to accept the selection and enter the Filter Cycle Start Time program-
ming mode.