Dimension One Spas 1998

1998

’

ual

1) Before filling your spa, install the black plastic hose bib that is

included in the owner's manual packet located in the equipment com-

partment. Screw it onto the male fitting at the bottom of the spa on

the pedestal, to the lower left of the equipment compartment. Close

the valve and screw the cap onto the end of the bib. Check the pump

unions to be sure that they are tight to prevent the possibility of leak-

age in the equipment compartment. Also, open both bleeder valves

located in the skimmer area.

2) Fill your spa with water to a level of one to two inches above the bot-

tom of the tile line.

3) Turn on the circuit breaker. After a 5 second diagnostic check, the

ozone generator and circulation pump will come on. Similarly, the

“SET CLOCK” message will be indicated on the upper line of the

LCD display. If you do not set the proper time, the system will

default to 11:59 A.M.. For more information about programming

functions, please see page 30. One minute after the system power is

first initiated, the internal time clock is automatically set to initiate

the first filtration cycle. The filtration system factory default is two,

one hour cycles.

4) Push the JETS 2 pad to prime the second pump. Let the system run

for 30 to 45 seconds to prime the pumps. If there is no jet action,

then the water level is too low or there is air trapped in the plumbing

lines. To eliminate the trapped air, turn the pumps on and off several

times to force the trapped air through the pumps. If there is still no

jet action, and the bleeder valves have been open for some time, turn

off the pumps and loosen the top pump unions slightly to let any

trapped air escape. Re-tighten the pump unions and turn the on the

pumps again. Turn the pumps on and off several times until jets func-

tion properly.

NOTE: Bubbles will continue to release from the skimmer recess Ultra

Pure bleeder valve as long as the valve remains open. This is a normal

function.

DIP

IRM

I -