Dimension One Spas 1998

1998

’

ual

5) When the jets are in full operation, close both bleeder valves and

push the UP pad until the desired spa temperature is indicated on the

display screen. In a few seconds, the screen will start displaying the

current spa water temperature again. The maximum temperature that

can be set is 104˚ F, OR5, or OR6.

NOTE: The LCD display will read out the temperature up to 104˚ F.

When the temperature exceeds 104˚ F, the display will read in “over-

range” figures. I.E. at 105˚ F the temperature will read "OR5" and at

106˚ F the temperature will read "OR6". Water temperatures in excess of

104˚ F should be used with extreme caution.

NOTE: On initial start-up, you can confirm that the heater is on by

looking to see that the heat LED indicator located on the right side of the

spa control panel is dimly illuminated. A scrolling message will also

appear on the lower line of the LCD reading SPAHEATING TO XXX˚ F

(whatever the set temperature is). Once you have verified that the heater

is functioning, you can reinstall the ventilated equipment access panel.

NOTE: Depending upon the size of the spa, heating will occur at the

rate of 4-8˚ F per hour.

6) After completing the above steps, it is necessary to ensure proper

water chemistry. See the Water Chemistry section in this manual, for

the easy steps to maintaining clean and safe water. The schedule

shown may require more frequent adjustment depending on the bather

load.

7) Place the thermal cover on the spa to conserve energy and to keep it

ready for use.