Dimension One Spas Dynamic Massage Sequencer Using the Scrolling Message Center, Setting the Time

2002 Dimension One Spas Export Owner’s Manual

Using the Scrolling Message Center

Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through customizing your hot tub to your exact needs. To initiate the programming sequence at any time, push and hold the Program pad for 3 seconds. If, within 10 seconds, you do not proceed with the hot tub programming, the hot tub will automatically exit the programming sequence and revert to the pre-set factory default settings. To exit the programming sequence at any time, push the Enter pad or do not press a pad for 10 seconds. Any programming changes made up to that point are saved.

Setting the Time

After holding the PROGRAM pad, the top line of the Digital Display will read “SET TIME OF DAY” and the bottom line will read “PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO SELECT NEXT FUNCTION

-PUSH ENTER TO EXIT ”. Push the UP or DOWN pads to engage the time setting mode. The time screen will appear with “hours” (_ _.00) flashing on and off. Push the UP or DOWN pad to increase or decrease the number until the desired hour appears. When the desired number is displayed, push the LIGHT pad to accept the selection and change the flashing number to the “ten minute” place (12:_0). Adjust the number with the UP or DOWN pad in the same manner as the hour number. When the desired indicator is displayed, push the LIGHT pad to accept the selection and change the flashing number to the “minute” place (12:1_). Adjust this number with the UP or DOWN pad in the same manner as the hour number. When the desired number is displayed, push the LIGHT pad to accept the selection and change the flashing number to a flashing AM or PM indicator. Adjust the indicator with the UP or DOWN pads. After reaching the correct time, push the PROGRAM pad to set the time and exit the time setting mode. You will then be prompted to set the filter start time.

Filter Cycle Start Time

After setting the time-of-day, the top line of the Digital Display will read “SET FILTER CYCLE TIME”. Push the UP or DOWN pads in the same manner as setting the clock to select the time you want your filter cycle to start. When your desired filter cycle start time is set in the display, push the PROGRAM pad to continue. The pre-set factory default is 12:00 p.m. to 1:00 p.m. repeating every 12 hours unless the number of filter cycles per day has been changed.

Keep in mind that you will later be prompted to set the filter cycle duration and the number of filter cycles. Be sure to keep this in mind when programming your filter cycle start time.

Note

During a filter cycle, the bottom left of the Digital Display will read “SPA FILTERING”. During the filter cycle, JETS 1 will activate, the first 5 minutes at high speed and the remainder of the filter cycle time at low speed. JETS 2 will also activate for 1 minute on high speed and then turn off.

Filter Cycle Duration

After setting the filter cycle start time, the top line of the Digital Display will read “SET CYCLE DURATION”. Push the UP or DOWN pads to toggle between 60, 90, 120, 150 and 180 minutes. The first 5 minutes of the filter cycle will be at high speed and the remaining time at low speed. When your desired filter cycle length appears in the Digital Display, push the PROGRAM pad to select it. The pre-set factory default is 60 minutes.

Number of Filter Cycles

After setting the length of the filter cycle, you will be prompted to set the number of filter cycles. The top line of the Digital Display will read “SET # OF CYCLES”. Push the UP or DOWN pad to toggle from 1 to 2 to 3 to 4 cycles per day. When your desired number of cycles appears on the Digital Display, push the PROGRAM pad to select it. The pre-set factory default is 2 cycles per day.

Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot climates.

Caution

16