2002 Dimension One Spas Export Owner’s Manual
Clean Filters
On alternating months, the top line of your Digital Display will read, “DIRTY FILTER” and the message “REMOVE FILTERS & CLEAN IN SOLUTION... PUSH AND HOLD ICON PAD MORE THAN 3 SECONDS TO RESET THIS MESSAGE” will scroll from right to left on the bottom line of the display. To reset this message, push and hold the Dimension One Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
Change Water
Every four months the top line of your Digital Display will read “CHANGE WATER” and the message “TURN
POWER OFF, DRAIN & REFILL SPA...PUSH AND HOLD ICON PAD MORE THAN 3 SECONDS TO RESET THIS MESSAGE” will scroll from right to left on the bottom line of the display. To reset this message, push and hold the Dimension One Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
Change Vision Cartridge
When “CHANGE VISION CARTRIDGE” is displayed on the LCD, the system is telling you that it is time to replace it. To reset this message, push and hold the Dimension One Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
If you purchased a Vision cartridge subsequent to the initial start up of your hot tub, please follow the programming instructions for VISION as outlined in the next section (titled, “Vision Cartridge”) to set the
Note
Spa Check Up
When “SPA CHECK UP” is displayed on the Digital Display, we recommend that you have your hot tub inspected by your dealer as a preventative maintenance measure. To reset this message, push and hold the Dimension One Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
The system can dismiss and reset the maintenance messages by pushing and holding the Dimension One Spas ICON (logo), on the right end of the control, for 3 seconds. If you press the Dimension One Spas ICON (logo) for 5 seconds when there is no maintenance message, it will put the spa in the “Standby” mode.
Note
Overheat
When “OVERHEAT” is displayed on the control system Digital Display, the hot tub is in a high temperature condition. If such a condition exists, check water temperature and if it is above 104° F (40° C), DO NOT ENTER THE WATER. If this happens, remove the hot tub cover and allow the water to cool below 110° F (43.3° C). Reset the power to the spa by resetting the GFCI breaker. If the problem recurs, turn off all power to the hot tub and contact your local Authorized Dimension One Spas Dealer, or authorized service center.
Flashing Display and/or “Check Water Level”
If you see 3 flashing LEDs (on Digital Display) and/or the message, “CHECK WATER LEVEL
Flashing Temperature on the Display
If you see a flashing temperature of 34° F (1.11° C) or 134° F (56.6° C), DO NOT ENTER THE WATER. The system has detected a problem. Call your dealer for service.
14
