Code Scanning To use the Code Scanning method:
1. Repeatedly tap the top part of the CHANNEL (CH) button.
P
CH A
G
E
Changing the Remote ID
2.Continue to step through the codes until the component turns off, indicating you have found the correct component code. If you accidentally pass a code that responds or realize you may not have been aiming the remote control at the component, tap the lower part of the CHANNEL (CH) button to step backward through the codes.
3.Press the remote control POWER button to verify the proper code by turning the device on and off.
4.Press the device button (in this example, TV) again to lock in the code.
If you are using multiple satellite receivers in the same room, you may want to change the remote control ID to avoid interference or “cross talk.” The remote control ID can be a number from “001” to “008”.
If you change remote IDs, set your remote control to that ID number first. Use this procedure to set the remote control to use a different remote ID:
Installing remote control batteries
1.From the MAIN MENU, highlight the System Setup menu tab. Press
SELECT.
2.Highlight Remote menu tab to access Remote Control Settings.
3.Highlight the Remote ID menu button.
4.Press and hold the remote control SAT button.
5.Press and release the MUTE button.
6.Release the SAT button. It should remain lit. If it does not, repeat steps
7.Enter desired number (001 to 008).
8.Press the SAT button to lock in the code.
9.Point the remote control at the receiver. Press SELECT.
The number to the right of the highlighted Remote ID menu button will change to the new code. Check that the ID has been successfully set by testing the remote control to see that it controls that satellite receiver.
To install or replace the remote control batteries:
1.Locate the battery compartment on the back of the remote control.
2.Remove the battery compartment cover.
3.Insert two “AAA” size batteries as shown, observing the correct polarity.
4.Replace the battery compartment cover.
