SECTION 1 - INSTALLATION
Order your telephone line at least two weeks prior to the planned installation date. This will assure that a phone line is available when the unit is installed. The telephone company will require the following information from you:
Type: | Touch Tone, Loop Start |
Ringer Equivalence: | 0.0 A |
Jack Type: | RJ11C |
FCC Registration (US): | |
DOC (Canada): | 1736 4528 A |
Electrical Listing: | Complies with U.L. 294 - ETL Listed |
CALLER ID: You may want to consider ordering caller ID blocking from the telephone company for the entry system phone line. Without caller ID blocking, tenants with the proper phone equipment will be able to identify the telephone number that the entry system is installed on. This may or may not be desirable.
1.1INSTALLATION GUIDELINES – ALL SYSTEMS
1.Open the cabinet of the telephone entry system and disconnect the keypad ribbon cable from the main circuit board.
2.Remove the
3.Remove the circuit board by gently pulling it out of the main terminal edge connector. CAUTION - the circuit board contains static sensitive components. Discharge any static electricity from your hands by touching a proper ground device before removing the circuit board. Place the circuit board where it will not be damaged.
4.Mount the cabinet of the telephone entry system. Be sure that mounting screws do not protrude into the cabinet where they could cause a short on the back of the circuit board. Make any necessary conduit connections.
5.Route wiring into the cabinet. Do not apply any power at this time.
6.Clean out the cabinet. Be sure that all dirt, metal and/or wood debris is removed from the cabinet and that the terminal strip edge connector is clean and free of any loose particles.
7.
8.Secure the circuit board to the cabinet using the screws removed in step 2.
9.Plug the keypad ribbon cable into the circuit board. The cable points down.
9
