SECTION 3 – PROGRAMMING
The DoorKing 1802, 1803, 1808 and 1810 Telephone Entry Systems can be programmed from the keypad on the front of the entry system, or remotely from an off premise location using a touch tone telephone. When programming from an off site location with a
Programming from the Keypad
Follow the programming instructions as described in each section of this manual. The system will prompt you with short (beep) tones when programming steps have been followed correctly, and with a long tone (beeeeeep) when the programming step is ended. The 1802, 1803 and 1810 systems have an LCD display that will prompt you for information that you will need to enter.
Programming from an Offsite Location
Follow these steps when programming the system from an offsite location. You must use a touch- tone telephone and the RING pin must be installed to perform off site programming.
1.Call the telephone number that the entry system is installed on from a
2.Follow the programming instructions as described in each section of this manual. The system will prompt you with short (beep) tones when programming steps have been followed correctly.
3.When complete, hang up. (You cannot use 0 # to end remote programming sessions).
Programming Notes
When each programming step is performed correctly, a short tone (beep) will be heard. When the programming session is ended, a long tone (beeeeeep) will be heard.
This symbol Bin the programming steps indicates numbers that you will need to enter, one number per symbol.
The amount of telephone numbers that can be programmed into the system is dependent on the memory size ordered. Memory sizes available are 25 - 75 - 125 - 250 - 500 - 1000. The memory size also determines the number of
27
