DMP Electronics SCS-1R manual Line Cards

Change Rec Key

Sure? YES NO

Receiver key changed

RECEIVER Hours from GMT: 6

Operator’s Guide

Change Receiver Key

After entering the desired Receiver Key and pressing COMMAND, the SURE? YES NO prompt displays. Press the Select key under YES to keep the new key, or under NO to use the previously stored key.

Receiver Key Changed

After pressing the Select key under YES, the display indicates that the receiver key has been successfully changed.

Receiver Hours From GMT

Number of hours (0 to 23), from the Greenwich Time zone (GMT), where the receiver is located. Refer to the table below for various cities and GMT settings. Default is 6.

GMT	City/Time Zone	GMT	City/Time Zone
0	London, Monrovia, Lisbon, Dublin, Casablanca, Edinburgh	13	New Cadelonia
1	Cape Verde Island, Azores	14	Guam, Sydney
2	Mid-Atlantic, Fernando de Noronha	15	Tokyo, Seoul
3	Buenos Aires, Georgetown, Brasilia, Rio de Janeiro	16	Hong Kong, Singapore
4	Atlantic Time (Canada), Caracas, La Paz, Santiago	17	Bangkok, Hanoi
5	Eastern Time (US, Canada) Bogota, Lima, Arequipa	18	Dhaka, Almaty
6	Central Time (US, Canada), Mexico City, Saskatchewan	19	Islamabad, Karachi
7	Mountain Time (US, Canada), Edmonton	20	Abu Dhabi, Kazan
8	Pacific Time (US, Canada), Tijuana	21	Moscow, Bagdad
9	Alaska	22	Eastern Europe
10	Hawaii	23	Rome, Paris, Berlin
11	Midway Island, Samoa
12	Fiji, Marshall Island, Wellington, Auckland, Kwajalein, Kamchatka

Dialer LINE CARD MONITOR? No yes

Line Cards

Dialer Line Card Monitor

Press the far right Select key for YES to enable monitoring of all SCS-100 digital dialer line cards for any failed communication attempts. A failed communication attempt occurs when the line card goes off hook but does not successfully communicate with a panel. Press the middle right Select key for NO, to disable the line card monitoring operation. Default is NO.

When enabled, and a line card communication fails, a message, S61 through S65 (Line 1-5 respectively), is sent to the host automation computer, SCS-1R printer and LCD display. Manual acknowledgement is required when the SCS-1R is not successfully communicating with the host automation computer.

This section assigns the line number and line type for all line cards connected to the SCS-150.

SCS-1R MENU Line CARDS

Line NUMBER: X

Line NUMBER: X

Type: XXXX

Line TYPE

NONE DD NET

SEND TIME CHANGE TO PNLS? NO YES

Line Cards

Press any top row Select key to assign the line number and line type for each line card connected to the SCS-150.

Line Number

Press any top row Select key to clear the display and enter a new line number. Enter the line number, 1 through 5, for which the communication method is to be specified.

Line Type

The display shows the current setting for the line type. Press any top row Select key to change the Line Type. Press the Select key under the communication method for this line. NET for Data Network communication for use with data networks. DD for DMP Digital Dialer. NONE to clear all information for the line. Line 1 defaults to NET and lines 2 through 5 default to DD. After you select the line type, the display returns to LINE NUMBER: to program the other lines.

Send Time Change

Press the top row Select key under YES to allow the SCS-1R to send time changes to panels that communicate to the receiver on this line card. Select NO to prevent the SCS-1R Receiver from sending time changes.

SCS-1R Installation Guide Digital Monitoring Products

21