>Confirm by pressing OK.

The menu Settings will be displayed. (Fig. 6-7)

>Now use the arrow keys up/down to select the line Antenna Configuration.

>Confirm by pressing OK. The menu Antenna

Configuration will be displayed. (Fig. 6-8)The following settings may be made in this sub-menu:

6.4.1 Switching DiSEqC on or off

DiSEqC (Digital Satellite Equipment Control) is a digital swit- ching signal used to control DiSEqC-compatible components via the antenna cable. If your external installation incorpora- tes DiSEqC components, you must switch on (enable) the DiSEqC control:

>In this line, use the OK key to select DiSEqC on or off.

As only one LNC can be addressed if the DiSEqC control is switched off, the menu is restricted to the configuration of a single LNC.

6.4.2 Setting the switching matrix

The menu lists the four switching criteria of the DiSEqC con- trol. Your receiver is pre-programmed so that ASTRA will be received on the position A/A and Eutelsat on the position B/A of a multiswitch. If the switching matrix of your receiving installation is set up differently, or if you are receiving other satellites, proceed as follows to adjust your digital receiver to the requirements of your receiving installation.

>Use the arrow keys to select a DiSEqC switch posi- tion (1-4) you wish to allocate to a particular satellite (e.g. A/B 3 No Satellite), by simply marking this line.

>Confirm by pressing OK.

A selection table listing various satellites will be displayed.

>Use the arrow keys up/down to mark the appro- priate satellite.

The arrow keys up/down will move the marker up or down one line at a time, the arrow keys right/left will move forward or backward one page at a time.

If the satellite you seek is not included in the list, plea- se select one of the reserve slots, designated User 1 to User 14.

>Confirm by pressing OK. The satellite selected will now be added to the menu Antenna Configuration at the position previously marked.

(Fig. 6-7)

(Fig. 6-8)

Example:

A

B

A

B

Position

Position

Ausgang

Ausgang

A B

Option

Ausgang

21

Page 21
Image 21
Dolby Laboratories Digital-Satellite-Receiver manual Switching DiSEqC on or off, Setting the switching matrix