General features
WOW Control
1Select the source to adjust Press the [SRC] button.
2Select the key function section Press the [NEXT] button.
Repeatedly press the button until "WOW" is displayed above the [4] button.
Refer to <Notes on
3Enter WOW Control mode Press the [4] ("WOW") button.
•When "2 ZONE" of <Audio Setup> (page 12) is ON, you cannot select "WOW".
4Select the WOW Control item to adjust Press a [1] — [5] button.
WOW Control Item | ||
[1] | "EFFECT" | Effect |
[2] | "FOCUS" | FOCUS |
[3] | "TB_F" | TruBass Front |
[4] | "TB_R" | TruBass Rear |
[5] | "SRS 3D" | SRS 3D |
5Adjust the WOW control item
Push the Control knob towards [4] or [¢].
Each time you push the knob, the setting alternates between the settings shown in the table below.
WOW Control Item | Range |
Effect | Mid/High/User/Through/Low |
FOCUS | OFF/1 — 9 |
TruBass Front | OFF/1 — 4 |
TruBass Rear | OFF/1 — 4 |
SRS 3D | OFF/1 — 4 |
•WOW: TruBass, FOCUS and SRS 3D are all set to values shown in the table below.
| WOW TruBass | FOCUS | SRS 3D | |
| High | 4 | 8 | 4 |
| Mid | 3 | 6 | 2 |
| Low | 2 | 3 | 1 |
16 | English |
|
|
•FOCUS: Adjusts the vertical position of the front speaker and sound image by virtual adjustment.
•TruBass: Assists the playback for the super bass sound.
•SRS 3D: Makes a natural 3D sound field.
•You cannot set SRS 3D in tuner source.
6Exit WOW Control mode Press the [6] ("RTN") button.
• To get the best sound, first set the Speaker select.
Bypass Control
Temorarily bypassing DSP (Digital Signal Processor) System.
1Select the source to adjust Press the [SRC] button.
2Select the key function section Press the [NEXT] button.
Repeatedly press the button until "On Off" is displayed above the [5] button.
Refer to <Notes on
3Enter Bypass Control mode Press the [5] ("On Off") button.
•When "2 ZONE" of <Audio Setup> (page 12) is ON, you cannot select "On Off".
4Set up Bypass
Push the Control knob towards [4] or [¢].
"Bypass": There is no effect by DSP.
"Through": There is an effect by DSP.
•When operation stops for 3 seconds, the Bypass Control mode closes.
•When the mode is set to "Bypass", DSP System cannot be adjusted.
•When the mode is set to "Bypass", ODD D/A System is not effective.
05.11.15 2:35:43 PM |