•"Preset": You can store an adjusted audio control value by selecting "MEM". Refer to <Memory mode> (page 17). Also, you can recall it by selecting "RCL". Refer to <Memory Recall mode> (page 17).
•X'Over (Crossover Network Setup)
You can manually set a crossover frequency for the speakers.
•DTA (Digital Time Alignment)
Manually set the sound output timing of each channel.
5Adjust the Sound Field Control item Push the Control knob towards [4] or [¢].
Each time you push the knob, the setting alternates between the settings shown in the table below.
Sound Field Control Item | Range |
Front High Pass Filter Center/ | Through/30 — 100/120/150/ |
Rear High Pass Filter Center*2 | 180/220/250 (Hz) |
Front High Pass Filter Slope/ | |
Rear High Pass Filter Slope*2/ |
|
Subwoofer Low Pass Filter Slope*1 |
|
Subwoofer Low Pass Filter Center*1 | 30 — 100/120/150/180/220/ |
| 250 (Hz)/Through |
Subwoofer Low Pass Filter Phase*1 | Reverse/ Normal |
DTA Front/DTA Rear*2 | 0 — 610 (cm) |
DTA Subwoofer*1 |
|
Position Setting |
•When the "2 ZONE" of <Audio Setup> (page 12) is "ON", the following setups are ignored.
-"XOver"
-"DTA"
-"POSI"
-"Preset"
•*1 You can control this item when <Subwoofer Output> (page 11) is set to "SW ON".
•*1 You can control this item when Speaker Select Subwoofer of <Sound Management system> (page
14)is set to any item other than "None".
•*2 You can control this item when Speaker Select Rear of <Sound Management system> (page 14) is set to any item other than "None".
6Exit Sound Field Control mode Press the [6] ("RTN") button.
English 13
05.11.15 2:35:42 PM |
