Dolby Laboratories KDC-W8534 instruction manual Display Type Selection

Display Type Selection

Changing the display mode.

1Select the key function section Press the [NEXT] button.

Repeatedly press the button until "DISP" is displayed above the [6] button.

Refer to <Notes on Multi-function Key System> (page 9).

2Enter display control mode Press the [6] ("DISP") button.

3Select the display mode Press the [1] ("MODE") button.

4Select the display Type

Push the Control knob towards [4] or [¢].

Each time you push the knob, the display mode alternates between the display modes shown in the table below.

Display Mode	Display
"Display Type A"	1
"Display Type B"	1
							2
"Display Type C"
		3					4
		3					5
		3					6
"Display Type D"
					4				7
					6
			8	8		8	8	8		8

1 Graphic display part

2Text display part

3Text icon display part

4 Upper text display part

5 Middle text display part

6 Lower text display part

7 Source icon display part

8 Function item display

5Exit display control mode Press the [6] ("RTN") button.

•Under the display type other than "Display Type D", the function item is not displayed. When you select the display type other than "Display Type D", press [1] to [6] buttons or [NEXT] button. The function item will be displayed approximately 5 seconds.

•The indicator is displayed when the display type is set to "Display Type C" or "Display Type D".

•Change the information by the Display Type. Refer to the page on the following table for the methods to alternate by the Display Type.

Display Type	A	B	C	D
Graphic 1	20	20	—	—
Text 2	—	21	—	—
Upper 4	—	—	22	22
Middle 5	—	—	23	—
Lower 6	—	—	23	23

English 19

B64-3304-00_01_E_English.indd 19 05.11.15 2:35:45 PM