Troubleshooting Guide
Audio file source
?Cannot play an Audio file.
✔The media is scratched or dirty.
☞Clean the media, referring to the CD cleaning of the section on <About CDs> (page 7).
?The sound skips when an Audio file is being played.
✔The media is scratched or dirty.
☞Clean the media, referring to the CD cleaning of the section on <About CDs> (page 7).
✔The recording condition is bad.
☞Record the media again or use another media.
?The Audio file track time isn’t displayed correctly.
✔
☞There are times when it isn’t displayed correctly according to the Audio file recording conditions.
The messages shown below display your systems condition.
Eject: | No disc magazine has been loaded in |
| the changer. The disc magazine is not |
| completely loaded. |
| ➪ Load the disc magazine properly. |
| No CD in the unit. |
| ➪ Insert the CD. |
No Disc: | No disc has been loaded in the disc |
| magazine. |
| ➪ Load a disc into the disc magazine. |
TOC Error: | No disc has been loaded in the disc |
| magazine. |
| ➪ Load a disc into the disc magazine. |
| The CD is quite dirty. The CD is upside- |
| down. The CD is scratched a lot. |
| ➪ Clean the CD and load it correctly. |
Error 05: | The CD is |
| ➪ Load the CD correctly. |
Blank Disc: | Nothing has been recorded on the MD. |
No Track: | No tracks are recorded on the MD, |
| although it has a title. |
Error 15: Media was played that doesn’t have data recorded that the unit can play.
➪Use media that has data recorded that the unit can play.
No Music Data: Media was played that doesn’t have data recorded that the unit can play.
➪Use media that has data recorded that the unit can play.
Files for picture downloading only are recorded in
No Panel: | The faceplate of the slave unit being |
| connected to this unit has been removed. |
| ➪ Replace it. |
Error 77: The unit is malfunctioning for some reason.
➪Press the reset button on the unit. If the "Error 77" code does not disappear, consult your nearest service center.
Mecha Error: Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.
➪Check the disc magazine. And then press the reset button on the unit. If the "Mecha Error" code does not disappear, consult your nearest service center.
56 English
05.11.15 2:36:04 PM |
