Dukane 9136 Electrical power cord is not plugged, Power switch is not set to the on position

Troubleshooting

Phenomena that may be easy to be mistaken for machine defects

WARNING ►Never use the projector if abnormal operations such as smoke, strange odor, excessive sound, damaged casing or elements or cables, penetration of liquids or foreign matter, etc. should occur. In such cases, immediately turn off the power switch and then disconnect the power plug from the power outlet. After making sure that the smoke or odor has stopped, contact your dealer or service company.

1. Before requesting repair, please check in accordance with the following chart. This operation sometimes resolves your problem. If the situation cannot be corrected,

2. The projector’s microprocessor may need to be reset.

Please push the Shutdown switch by using a pin or similar and the projector will be turned off immediately. Before turning it again, wait at least 10 minutes to make the projector cool down enough.

3. Some setting may be wrong. Please use the FACTORY RESET function of the SERVICE item in the OPTION menu (48) to reset all settings to factory default.

Then, if the problem is not removed after the remedy, please contact your dealer or service company.

Phenomenon

Cases not involving a machine defect

Reference

page

	The electrical power cord is not plugged in.				12
	Correctly connect the power cord.
	The power switch is not set to the on position.				16
	Set the power switch to [		] (on).
	The main power source has been interrupted during
Power does not	operation such as by a power outage (blackout), etc.				16
	Please turn the power off, and allow the projector to cool
come on.	down at least 2 minutes, then turn the power on again.
	Either there is no lamp and/or lamp cover, or either
	of these has not been properly fixed.
	Please turn the power off, and allow the projector to cool down at				63
	least 45 minutes. After the projector has sufficiently cooled down,
	please make confirmation of the attachment state of the lamp and
	lamp cover, and then turn the power on again.
	The signal cables are not correctly connected.				10
	Correctly connect the connection cables.
	Signal source does not correctly work.
	Correctly set up the signal source device by referring to the				–
Neither sounds	manual of the source device.
	The input changeover settings are mismatched.
nor pictures are					17, 18
outputted.	Select the input signal, and correct the settings.
	The BLANK function for pictures and the MUTE
	function for sounds are working.
	AV mute may be active. Refer to the item “Sound does not				17, 22
	come out” and “No pictures are displayed” on the next page
	to turn off the MUTE	and		BLANK functions.
(Continued on next page)					71