Troubleshooting

1. Power LED is not lit

Check if the power cord is properly connected to the power outlet and the switch. Make sure the power switch at the rear panel is turned ON.

2.Link LED is not lit when connected to the network device

(1)Make sure the power switch of the network device is turned on

(2)Check if the network cable is properly connected to the switch and the network device

(3)Make sure the UTP cables comply with EIA/TIA 568 and Category 5 specification

3.Collision LED flashes constantly

(1)Remove all the network cables; connect the cables back one by one to isolate the source of the collision.

(2)Check the network cable, inferior cable quality will result in excessive collisions and packet errors.

[!] Contact your dealer if problems persist.

98

Page 98
Image 98
Edimax Technology ES-5224RM, ES-5224REM Power LED is not lit, Link LED is not lit when connected to the network device