49
Chapter7Troubleshooting
7-4. Built-in calibration sensor and SelfCalibration problems
Problem Possible cause and remedy
1. The built-in calib ration sensor does not
come out/stays out.
• Turnoffthemainpower,andthenturnitonagainafew
minuteslater.
2. SelfCalibr ation cannot be executed. •Checkwhetherthedateandti mearesetcorrectly(see“4-
2.SettingMonitorDateandTime”(page36)).
• Checkwhetherthemodeisset(see“4-3.Setting
CalibrationSchedule”(page36)).
• Checkwhetherthecalibrationtargetsaresetcorrectly(see
“4-4.Settingthecalibrationta rgets”(page38)).
• SettheSelfCalibrationtargetusingCo lorNavigator.
3. SelfCalibra tion failure • Refertotheerrorcodetable.Ifanerrorc odethatdoes
notappearintheerrorcodetableisdispl ayed,contact
yourlocalEIZOrepresentative.

Error Code Table

Error Code Description

0014 • ExecuteSelfCalibrationagain.
• AdjustusingColorNavigator.
0034 • Thebuilt-incalibrationsensormaynothavec omeoutduringcalibration,orlightmay
haveenteredthesensorduringmeasurement.
• Turnoffthemainpower,waitforafewminutesbeforeturningthepowerbackon,and
thenexecuteSelfCalibrationagain.
0050 • ExecuteSelfCalibrationagain.
0061 • Thebuilt-incalibrationsensormaynothavewor kedcorrectly.
• Checkwhetherthereisanyforeignobjectneart hebuilt-incalibrationsensor.
• ExecuteSelfCalibrationagain.