This function is used to select which PC will have priority to control the monitor when utilizing two PCs.
The monitor constantly checks the input signals and switches automatically in accordance with the "Input
Priority" setting (see table below). Once a priority is set, whenever a change of signal is detected at the
selected input, the monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically detects and displays
that signal.
Priority setting Performance
1
(SIGNAL 1 - DVI-I Input Connector)
If signals from both inputs are present, the monitor gives preference to
Signal 1 in the following cases.
● When the power of the monitor is turned ON.
● When the signal input to Signal 1 is changed even if active input was
Signal 2 (Analog input only).
2
(SIGNAL 2 - DVI-I Input Connector)
If signals from both inputs are present, the monitor gives preference to
Signal 2 in the following cases.
● When the power of the monitor is turned ON.
● When the signal input to Signal 2 is changed even if active input was
Signal 1 (Analog input only).
Manual The monitor will not detect signals automatically in this mode. Select the
active input by pressing the Input Signal Selection Button on the monitor's
control panel.
● When the "1" or "2" is selected, the power saving mode of the monitor activates only if both PCs are in
power saving mode.